Complete Installation
Operate the unit at all levels to verify proper operation.
Foot Plate Assembly
Tools Required:
• 5/32” Allen wrench
• Loctite
®
#242
Remove foot plate assembly
1. Remove both SHCS and washers securing foot plate using a 5/32” Allen wrench.
Qty.DescriptionItem
2SHCS1
2Washer2
1Foot plate3
1Front foot plate shaft4
1Rear foot plate shaft5
2. Remove foot plate from front and rear foot plate shafts.
Install foot plate assembly
1. Slide foot plate onto the foot plate shafts.
Qty.DescriptionItem
2SHCS1
2Washer2
1Foot plate3
1Front foot plate shaft4
1Rear foot plate shaft5
1Loctite
®
#2426
2. Place a drop of loctite on each SHCS.
Place another drop of loctite in each shaft (where the SHCS will be tightened into).
3. Install both washers and both SHCS using a 5/32” Allen wrench.
Page 105 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
