CYBEX Arc Trainer 772A - Page 145

Remove left shroud
1. Remove eight screws securing left shroud using a long Phillips screwdriver.
Qty.DescriptionItem
7Screw1
1Left shroud2
2. Remove left shroud.
Remove incline motor cable
1. Remove controller cover using a Phillips screwdriver.
Qty.DescriptionItem
1Cable tie1
1Incline motor cable2
1Controller cover3
1Control board4
1Screw5
2. Remove controller cover.
3. Unplug incline motor cable from control board.
4. Cut cable tie using side cutters.
Page 145 of 202
Cybex 772A, 772AT Arc Trainer Part Number