CYBEX Arc Trainer 772A - Page 146

Remove incline motor
1. Remove retaining ring from motor mount shaft using retaining ring pliers.
Qty.DescriptionItem
1Retaining ring1
1Motor mount shaft2
1Incline motor3
2. Remove motor mount shaft securing incline motor to main frame.
3. Remove incline motor.
Install incline motor
1. Place incline motor in position.
2. Plug the incline motor cable into control board.
Qty.DescriptionItem
1Cable tie1
1Incline motor cable2
1Controller cover3
1Control board4
1Screw5
3. Plug power cord into power inlet.
4. Turn the power switch on.
5. Wait for shaft on incline motor to stop turning.
6. Unplug power cord from power inlet.
Page 146 of 202
Cybex 772A, 772AT Arc Trainer Part Number