CYBEX Arc Trainer 772A - Page 147

7. Turn the tube nut with your fingers until it measures the correct center to center length. This length
is measured from the center of the top hole to the center of the bottom hole.
Qty.DescriptionItem
1Tube nut1
11.50" (29
cm)
Center to center
length
2
8. Install a retaining ring to one side of motor mount shaft using retaining ring pliers.
Qty.DescriptionItem
1Retaining ring1
1Motor mount shaft2
1Incline motor3
9. Install motor mount shaft securing the incline motor to drive frame assembly.
10. Install a retaining ring to other side of motor mount shaft using retaining ring pliers.
11. Install cable tie securing incline motor cable.
Remove excess cable tie with side cutters.
12. Install controller cover and screw using a Phillips screwdriver.
Install left shroud
Install eight screws securing left shroud in place using a long Phillips screwdriver.
Page 147 of 202
Cybex 772A, 772AT Arc Trainer Part Number