CYBEX Arc Trainer 772A - Page 148

Qty.DescriptionItem
7Screw1
1Left shroud2
Install lower motor mount shaft
1. Tilt front end assembly backward carefully until holes in incline motor align with the holes in the
support bracket on main frame.
2. Attach a retaining ring to one side of motor mount shaft using retaining ring pliers.
Qty.DescriptionItem
1Motor mount shaft1
1Retaining ring2
1Incline motor3
3. Install the motor mount shaft securing the incline motor to the main frame assembly.
4. Attach a retaining ring to the other side of motor mount shaft using retaining ring pliers.
Install incline motor cover
Install incline motor cover to main frame with two screws using a Phillips screwdriver.
Page 148 of 202
Cybex 772A, 772AT Arc Trainer Part Number