4.
Enter the sequence: .
5. At the main Toolbox screen, tap the OEM Diags icon, then the Incline Calibration icon.
6. Stop striding. Wait until foot plates come to a complete stop before dismounting unit. Hold handrails
to steady self while stepping off unit.
7. Press the Calibrate icon. The console will display Stay off of the pedals.
8. Press the Calibrate button to perform calibration. The console will display Calibrating... and the
incline motor will incline to it’s maximum extension and then return slightly.
When calibration is complete it will return to the Incline Calibration screen and display the calibration
numbers for 0 and 20%.
9.
Exit Diagnostics by tapping the Toolbox icon, then tap the Home icon . The screen will
refresh.
10. Tap QUICK START on the CardioTouch screen.
11. Press the Incline or keys once to lower the incline to a low starting position.
12. Press STOP key to return to Dormant Mode.
Install front access cover
Do not over tighten screws.
1. Place front access cover in place.
Qty.DescriptionItem
4Screw1
1Front access cover2
2. Install screws using a Phillips screwdriver.
Complete Installation
Operate the unit at all levels to verify proper operation.
Console Assembly
Accessory Tray
Tools Required:
• Phillips screwdriver
• Stubby Phillips screwdriver
Page 150 of 202
Cybex 772A, 772AT Arc Trainer Part Number
To Next Page
Loading...
Need help?
General
