EasyManuals Logo

CYBEX ATON Q User Manual

CYBEX ATON Q
99 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
7. Check the recline angle. Adjust the seat angle until the red line
on the Infant Carrier is level with the ground. A tightly rolled
towel or pool noodle may be placed under the Infant Carrier
near the vehicle seat back to adjust the angle. See page 42.
The Aton Q is allowed to touch the vehicle seat(s) in front of it, as long
the recline angle of the Aton Q is not affected.
8. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2.5 cm) in any direction.
If the Infant Carrier moves too much, tighten the vehicle belts more
and recheck. You may try a different vehicle seat or installation
method, or both.
9. If the Infant Carrier is next to a vehicle door or panel,
extend the adjacent L.S.P. device. See page 43.
FRONT OF VEHICLE
37
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
(Image shown from opposite side
compared to illustrations to the left)
7
9
ALWAYS have the handle locked in the upright DRIVE/
CARRY position while using this child restraint in a
vehicle.
NEVER INSTALL the Infant Carrier with both the Lap
and Shoulder Belts routed underneath BOTH Belt
Guides.
FRONT OF VEHICLE
INSTALLING INFANT CARRIER ONLY WITH A LAP/SHOULDER BELT

Table of Contents

Other manuals for CYBEX ATON Q

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CYBEX ATON Q and is the answer not in the manual?

CYBEX ATON Q Specifications

General IconGeneral
HeadrestYes
Washing typeMachine wash
CertificationECE R44/04
Mounting typeSeat belt
Product colorGreen
Car seat group0+ (0 - 13 kg; 0 - 18 months)
Country of originGermany
Belt fastening type3-point
Placement availableRear-facing
Maximum weight capacity13 kg
Maximum washing temperature30 °C
Number of headrest positions8
Quantity1
Weight and Dimensions IconWeight and Dimensions
Depth650 mm
Width440 mm
Weight4600 g
Height (max)560 mm
Height (min)390 mm

Related product manuals