D-Link DES-3326S - Page 169

D-Link DES-3326S Layer 3 Switch CLI Reference
show 802.1x
Purpose Used to display the current configuration of the 802.1x server on the Switch.
Syntax
show 802.1x [auth_state | auth_configuration] {ports <portlist>}
Description The show 802.1x command is used to display the current configuration of the
802.1x Port-based Network Access Control server application on the Switch.
Parameters auth_state – Displays the current 802.1x authentication state of the specified
ports.
auth_configuration - Displays the current 802.1x authentication configuration
of the specified ports.
ports <portlist> − Specifies a range of ports. The port list is specified by listing
the lowest Switch number and the beginning port number on that Switch,
separated by a colon. Then the highest Switch number, and the highest port
number of the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For example, 1:3
specifies Switch number 1, port 3. 2:4 specifies Switch number 2, port 4. 1:3-
2:4 specifies all of the ports between Switch 1, port 3 and Switch 2, port 4 − in
numerical order.
The following details what is displayed:
802.1x Enabled|Disabled − Shows the current status of 802.1x functions on
the Switch.
Authentication Protocol: − Shows the authentication protocol suite in use
between the Switch and a Radius server. The Switch supports EAP and PAP.
Port number − Shows the physical port number on the Switch.
Capability: Authenticator|None − Shows the capability of 802.1x functions on
the port number displayed above. There are four 802.1x capabilities that can
be set on the Switch: Authenticator, Supplicant, Authenticator and Supplicant,
and None.
Port Status: Authorized|Unauthorized − Shows the result of the authentication
process. Authorized means that the user was authenticated, and can access
the network. Unauthorized means that the user was not authenticated, and
can not access the network.
163