D-Link DES-3326S - Page 180

D-Link DES-3326S Layer 3 Switch CLI Reference
config radius
Purpose Used to configure the Switch’s Radius settings.
Syntax
config radius <server_index 1-3> {ipaddress <server_ip>
{ipaddress <server_ip>|key <passwd 32>|auth_port
<udp_port_number>|acct_port <udp_port_number>}
Description
The config radius command is Used to configure the Switch’s
Radius settings.
Parameters
<server_index 1-3> − Assigns a number to the current set of
Radius server settings. Up to 3 groups of Radius server settings
can be entered on the Switch.
<server_ip> − The IP address of the Radius server.
key − Specifies that a password and encryption key will be used
between the Switch and the Radius server.
<passwd 32> − The shared-secret key used by the Radius server
and the Switch. Up to 32 characters can be used.
default − Returns all of the ports in the range to their default Radius
settings.
auth_port <udp_port_number> − The UDP port number for
authentication requests. The default is 1812.
acct_port <udp_port_number> − The UDP port number for
accounting requests. The default is 1813.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure Radius settings:
DES-3326S:4#config radius 1 10.48.74.121 key dlink default
Command: config radius 1 10.48.74.121 key dlink default
Success.
DES-3326S:4#
174