D-Link DES-3326S - Page 285

D-Link DES-3326S Layer 3 Switch CLI Reference
disable ospf
Purpose Used to disable OSPF on the Switch.
Syntax
disable ospf
Description
This command, in combination with the enable
ospf command above, is used to enable and
disable OSPF on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this
command.
Usage Example
To disable OSPF on the Switch:
DES-3326S:4#disable ospf
Command: disable ospf
DES-3326S:4#
show ospf
Purpose Used to display the current OSPF state on the
Switch.
Syntax show ospf
Description This command will display the current state of
OSPF on the Switch, divided into the following
categories:
General OSPF settings
OSPF Interface settings
OSPF Area settings
OSPF Virtual Interface settings
OSPF Area Aggregation settings
OSPF Host Route settings
Parameters None.
Restrictions None.
279