D-Link DES-3326S - Page 300

D-Link DES-3326S Layer 3 Switch CLI Reference
show ospf lsdb
Purpose Used to display the OSPF Link State Database
(LSDB).
Syntax
show ospf lsdb {area_id
<area_id>|advertise_router <ipaddr>|type
[rtrlink|netlink|summary|assummary|asextlink]}
Description This command will display the current OSPF Link
State Database (LSDB).
Parameters
area_id <area_id> − A 32-bit number in the form of an
IP address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
advertise_router <ipaddr> − The router ID of the
advertising router.
type [rtrlink|netlink|summary|assummary|asextlink] −
The type of link.
Restrictions None.
NOTE: When this command displays a “*” (a star symbol) in the OSPF LSDB
table for the Area_id or the Cost, this is interpreted as “no area ID” for external
LSAs, and as “no cost given” for the advertised link.
Usage Example:
To display the link state database of OSPF:
DES-3326S:4#show ospf lsdb
Command: show ospf lsdb
Area LSDB Advertising Link State Cost
Sequence
ID Type Router ID ID Number
----------- -------------- --------------------------------------------------------------------
0.0.0.0 RTRLink 50.48.75.73 50.48.75.73 * 0x80000002
0.0.0.0 Summary 50.48.75.73 10.0.0.0|8 1 0x80000001
1.0.0.0 RTRLink 50.48.75.73 50.48.75.73 * 0x80000001
1.0.0.0 Summary 50.48.75.73 40.0.0.0|8 1 0x80000001
1.0.0.0 Summary 50.48.75.73 50.0.0.0|8 1 0x80000001
* ASExtLink 50.48.75.73 1.2.0.0|16 20 0x80000001
Total Entries: 5
DES-3326S:4#
294