D-Link DES-3326S - Page 67

D-Link DES-3326S Layer 3 Switch CLI Reference
show snmp host
Purpose Used to display the recipient of SNMP traps
generated by the Switch’s SNMP agent.
Syntax
show snmp host {<ipaddr>}
Description
The show snmp host command is used to
display the IP addresses and configuration
information of remote SNMP managers that are
designated as recipients of SNMP traps that are
generated by the Switch’s SNMP agent.
Parameters
<ipaddr> − The IP address of a remote SNMP
manager that will receive SNMP traps
generated by the Switch’s SNMP agent.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To display the currently configured SNMP hosts on the Switch:
DES-3326S:4#show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name SNMPv3 User Name
--------------- --------------------- -------------------- -----------------------------
10.48.76.23 V2c private
10.48.74.100 V3 authpriv public
Total Entries: 2
DES-3326S:4#
61