D-Link DGS-1510/ME Series - Chapter 14 Compound Authentication Command List

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
127
Chapter 14 Compound Authentication
Command List
enable authorization attributes
disable authorization attributes
show authorization
config authentication server failover [local | permit | block]
show authentication
14-1 enable authorization attributes
Description
This command is used to enable authorization.
Format
enable authorization attributes
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example sets authorization global state enabled:
DGS-1510-28XMP/ME:admin# enable authorization attributes
Command: enable authorization attributes
Success.
DGS-1510-28XMP/ME:admin#
14-2 disable authorization attributes
Description
This command is used to disable authorization.
Format
disable authorization attributes