DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
225
disable - Specifies to disable the trap state. This is the default option.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the trap state of the ERPS:
DGS-1510-28XMP/ME:admin# config erps trap enable
Command: config erps trap enable
Success.
26-8 show erps
Description
This command is used to display ERPS configuration and operation information.
The port state of the ring port may be as "Forwarding", "Blocking", "Signal Fail". "Forwarding" indicates that traffic
is able to be forwarded. "Blocking" indicates that traffic is blocked by ERPS and a signal failure is not detected on
the port. "Signal Fail" indicates that a signal failure is detected on the port and traffic is blocked by ERPS.
The RPL owner administrative state could be configured to "Enabled" or "Disabled". But the RPL owner operational
state may be different from the RPL owner administrative state, for example, the RPL owner conflict occurs.
"Active" is used to indicate that the RPL owner administrative state is enabled and the device is operated as the
active RPL owner. "Inactive" is used to indicate that the RPL owner administrative state is enabled, but the device
is operated as the inactive RPL owner.
Format
show erps
Parameters
None.
Restrictions
None.
Example
To display ERPS information:
To Next Page
Loading...
