D-Link DGS-1510/ME Series - Show Sntp

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
602
DGS-1510-28XMP/ME:admin# config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DGS-1510-28XMP/ME:admin#
74-2 show sntp
Description
This command is used to display SNTP current time source and configuration.
Format
show sntp
Parameters
None.
Restrictions
None.
Example
To show SNTP:
DGS-1510-28XMP/ME:admin#show sntp
Command: show sntp
Current Time Source : System Clock
SNTP : Disabled
SNTP Primary Server : 0.0.0.0
SNTP Secondary Server : 0.0.0.0
SNTP Poll Interval : 720 sec
DGS-1510-28XMP/ME:admin#
74-3 enable sntp
Description
This command is used to turn on SNTP support.
Format
enable sntp
Parameters
None.