D-Link DGS-1510/ME Series - Show Authentication

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
129
Format
config authentication server failover [local | permit | block]
Parameters
local - Specifies to use local DB to authenticate the client.
permit - Specifies that the client is always regarded as authenticated.
block - Specifies to block the client. This is the default.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the failover authentication state:
DGS-1510-28XMP/ME:admin# config authentication server failover local
Command: config authentication server failover local
Success.
DGS-1510-28XMP/ME:admin#
14-5 show authentication
Description
This command is used to display authentication global configuration.
Format
show authentication
Parameters
None.
Restrictions
None.
Example
To show authentication global configuration: