D-Link DGS-1510/ME Series - Show 802.1 X User; Config 802.1 X Auth_Protocol [Local | Radius_Eap]

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
39
4-5 show 802.1x user
Description
This command is used to display the 802.1X user.
Format
show 802.1x user
Parameters
None.
Restrictions
None.
Example
To display the 802.1X user information:
DGS-1510-28XMP/ME:admin# show 802.1x user
Command: show 802.1x user
Current Accounts:
Username Password
--------------- ---------------
test test
Total Entries:1
DGS-1510-28XMP/ME:admin#
4-6 config 802.1x auth_protocol
Description
This command is used to configure the 802.1X authentication protocol.
Format
config 802.1x auth_protocol [local | radius_eap]
Parameters
local - Specifies the authentication protocol as local.
radius_eap - Specifies the authentication protocol as RADIUS EAP.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.