D-Link DGS-1510/ME Series - Show Snmp Host

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
551
DGS-1510-28XMP/ME:admin# delete snmp host 10.0.0.1
Command: delete snmp host 10.0.0.1
Success.
DGS-1510-28XMP/ME:admin#
67-15 show snmp host
Description
This command is used to display the recipient for which the traps are targeted.
Format
show snmp host {<ipaddr>}
Parameters
<ipaddr> - (Optional) Enter the IP address used for the configuration here.
If no parameter is specified, all SNMP hosts will be displayed.
Restrictions
None.
Example
To show SNMP host:
DGS-1510-28XMP/ME:admin# show snmp host
Command: show snmp host
SNMP Host Table
Host IP Address SNMP Version Community Name / SNMPv3 User Name
--------------- --------------- ---------------------------------
10.90.90.3 V3 noauthnopriv initial
10.90.90.2 V2c private
10.90.90.1 V1 public
10.90.90.4 V3 authnopriv user123
10.90.90.5 V3 authpriv user234
Total Entries : 5
DGS-1510-28XMP/ME:admin#
67-16 config snmp engineID
Description
This command is used to configure an identifier for the SNMP engine on the Switch.