EasyManuals Logo

D-Link DGS-1510/ME Series User Manual

D-Link DGS-1510/ME Series
654 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #319 background imageLoading...
Page #319 background image
DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
315
Chapter 38
Link Layer Discovery Protocol
(LLDP) Command List
enable lldp
disable lldp
config lldp [message_tx_interval <sec 5-32768> | message_tx_hold_multiplier <int 2-10> | tx_delay <sec 1-
8192> | reinit_delay <sec 1-10>]
config lldp notification_interval <sec 5-3600>
config lldp ports [<portlist> | all] [notification [enable | disable] | admin_status [tx_only | rx_only | tx_and_rx |
disable] | mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable | disable] | basic_tlvs [{all} | {port_description |
system_name | system_description | system_capabilities}] [enable | disable] | dot1_tlv_pvid [enable | disable]
| dot1_tlv_protocol_vid [vlan [all | <vlan_name 32> ] | vlanid <vidlist>] [enable | disable] | dot1_tlv_vlan_name
[vlan [all | <vlan_name 32> ] | vlanid <vidlist> ] [enable | disable] | dot1_tlv_protocol_identity [all | {eapol | lacp
| gvrp | stp}] [enable | disable] | dot3_tlvs [{all} | {mac_phy_configuration_status | link_aggregation |
power_via_mdi | maximum_frame_size}] [enable | disable]]
config lldp forward_message [enable | disable]
show lldp
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
show lldp ports {<portlist>}
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports {<portlist>}
38-1 enable lldp
Description
This command is used to globally enable the LLDP function.
When this function is enabled, the Switch can start to transmit LLDP packets and receive and process the LLDP
packets. The specific function of each port will depend on the per-port LLDP setting.
For the advertisement of LLDP packets, the Switch announces the information to its neighbor through ports. For
the receiving of LLDP packets, the Switch will learn the information from the LLDP packets advertised from the
neighbor in the neighbor table. The default state for LLDP is disabled.
Format
enable lldp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DGS-1510/ME Series and is the answer not in the manual?

D-Link DGS-1510/ME Series Specifications

General IconGeneral
BrandD-Link
ModelDGS-1510/ME Series
CategoryNetwork Router
LanguageEnglish

Related product manuals