D-Link DGS-1510/ME Series - Chapter 25 Energy Efficient Ethernet (EEE) Command List

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
216
Chapter 25 Energy Efficient Ethernet (EEE)
Command List
config eee ports [<portlist> | all] state [enable | disable]
show eee ports {<portlist>}
25-1 config eee ports
Description
This command is used to enable or disable the EEE function on the specified port(s) on the Switch.
NOTE: EEE and ERPS are mutually exclusive functions.
Format
config eee ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
state - Specifies the EEE state. The default is disabled.
enable - Specifies to enable the EEE function for the specified port(s).
disable - Specifies to disable the EEE function for the specified port(s).
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the EEE state on ports 2-5:
DGS-1510-28XMP/ME:admin#config eee ports 2-5 state enable
Command: config eee ports 2-5 state enable
Success.
DGS-1510-28XMP/ME:admin#
25-2 show eee ports
Description
This command is used to display the EEE function state on the specified port(s).