DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
444
Example
To display FLASH utilization:
DGS-1510-28XMP/ME:admin#show utilization flash
Command: show utilization flash
Flash Memory Utilization :
Total Flash : 29937 KB
Used Flash : 28834 KB
Utilization : 96 %
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
51-6 clear counters
Description
This command is used to clear the Switch’s statistics counters.
Format
clear counters {ports <portlist>}
Parameters
ports - (Optional) Specifies a range of ports to be configured. The port list is specified by listing the
lowest switch number and the beginning port number on that switch, separated by a colon. Then
highest switch number, and the highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated by a dash.
<portlist> - Enter a list of ports used for the configuration here.
If no parameter is specified, system will display counters of all the ports .
Restrictions
Only Administrators and Operators can issue this command.
Example
To clear the Switch’s statistics counters:
DGS-1510-28XMP/ME:admin# clear counters ports 7-9
Command: clear counters ports 7-9
Success.
To Next Page
Loading...
Need help?
General
