D-Link DGS-1510/ME Series - Debug Software Command Command List; debug error_log

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
172
Chapter 18 Debug Software Command List
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
debug output [module <module_list> | all] [buffer | console]
debug config error_reboot [enable | disable]
debug config state [enable | disable]
debug show error_reboot state
debug show status {module <module_list>}
18-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP {<ipaddr> <path_filename 64>}]
Parameters
dump - Specifies to display the debug message of the debug log.
clear - Specifies to clear the debug log.
upload_toTFTP - Specifies to upload the debug log to a TFTP server specified by IP address.
<ipaddr> - (Optional) Enter the IPv4 address of the TFTP server.
<path_filename 64> - (Optional) Enter the pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrators can issue this command.
Example
To dump the error log: