D-Link DGS-1510/ME Series - Page 180

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
176
Restrictions
Only Administrators can issue this command.
Example
To set the Switch to not need a reboot when a fatal error occurs:
DGS-1510-28XMP/ME:admin# debug config error_reboot disable
Command: debug config error_reboot disable
Success.
DGS-1510-28XMP/ME:admin#
18-5 debug config state
Description
This command is used to set the state of the debug.
Format
debug config state [enable | disable]
Parameters
enable - Specifies to enable the debug state.
disable - Specifies to disable the debug state.
Restrictions
Only Administrators can issue this command.
Example
To set the debug state to disabled:
DGS-1510-28XMP/ME:admin# debug config state disable
Command: debug config state disable
Success.
DGS-1510-28XMP/ME:admin#
18-6 debug show error_reboot state
Description
This command is used to display debug error reboot state.