DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
211
DGS-1510-28XMP/ME:admin# config duld ports 1 state enable
Command: config duld ports 1 state enable
Success.
23-2 show duld ports
Description
This command is used to show unidirectional link detection information.
Format
show duld ports {<portlist>}
Parameters
<portlist> - (Optional) Enter a range of ports.
Restrictions
None.
Example
To show ports 1-4 unidirectional link detection information:
DGS-1510-28XMP/ME:admin# show duld ports 1-4
Command: show duld ports 1-4
Port Admin State Oper Status Mode Link Status Discovery Time(Sec)
----- ----------- ----------- -------- -------------- -------------------
1 Enabled Disabled Normal Unknown 5
2 Disabled Disabled Normal Unknown 5
3 Disabled Disabled Normal Unknown 5
4 Disabled Disabled Normal Unknown 5
To Next Page
Loading...
