D-Link DGS-1510/ME Series - config igmp_snooping

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
255
31-1 config igmp_snooping
Description
This command is used to configure IGMP snooping on the Switch.
Format
config igmp_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all] {state [enable | disable] |
fast_leave [enable | disable] | report_suppression [enable | disable]}(1)
Parameters
vlan_name - Specifies the name of the VLAN for which IGMP snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters long.
vlanid - Specifies the VLAN ID for which IGMP snooping is to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specifies to use all configured VLANs.
state - Specifies to enable or disable IGMP snooping for the chosen VLAN.
enable - Specifies to enable IGMP snooping for the chosen VLAN.
disable - Specifies to disable IGMP snooping for the chosen VLAN.
fast_leave - Specifies to enable or disable the IGMP snooping fast leave function.
enable - Specifies to enable the IGMP snooping fast leave function. If enabled, the membership is immediately
removed when the system receives the IGMP leave message.
disable - Specifies to disable the IGMP snooping fast leave function.
report_suppression - Specifies IGMP report suppression. When enabled, multiple IGMP reports or leave for a
specific (S, G) will be integrated into one report only before sending to the router port.
enable - Specifies to enable the IGMP report suppression.
disable - Specifies to disable the IGMP report suppression.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure IGMP snooping:
DGS-1510-28XMP/ME:admin# config igmp_snooping vlan_name default state enable
Command: config igmp_snooping vlan_name default state enable
Success.
DGS-1510-28XMP/ME:admin#
31-2 config igmp_snooping rate_limit
Description
This command is used to configure the rate of IGMP control packet that is allowed per port or per VLAN.