DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
284
Parameters
<ipaddr> - Enter the IP address used here.
mac_address - Specifies the MAC address of the entry being updated
<macaddr> - Enter the MAC address used here.
ports - (Optional) Specifies which ports are used for the IMPB entry being updated. If not specified, then it is
applied to all ports.
<portlist> - Enter the list of ports used here.
all - Specifies that all the ports will be used.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure an IMPB entry:
DGS-1510-28XMP/ME:admin# config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-
00-00-00-11
Command: config address_binding ip_mac ipaddress 10.1.1.1 mac_address 00-00-00-00-00-11
Success.
32-6 show address_binding
Description
This command is used to display the IMPB global settings or IMPB settings on specified ports.
Format
show address_binding {ports {<portlist>}}
Parameters
ports - (Optional) Specifies the ports for which the information is displayed. If not specified, all ports are
displayed.
<portlist> - (Optional) Enter the list of ports used here.
Restrictions
None.
Example
To show the IMPB global configuration:
To Next Page
Loading...
