DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
294
Restrictions
Only Administrators can issue this command.
Example
To print out all debug IMPB messages:
DGS-1510-28XMP/ME:admin# debug address_binding all state enable
Command: debug address_binding all state enable
Success.
32-19 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an ARP/IP packet or a
DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DGS-1510-28XMP/ME:admin# no debug address_binding
Command: no debug address_binding
Success.
To Next Page
Loading...
