D-Link DGS-1510/ME Series - Page 300

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
296
Format
delete ipv6 neighbor_cache ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
Parameters
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters long.
all - Specifies that all the interfaces will be used in this configuration.
<ipv6addr> - Enter the neighbor’s address.
static - Specifies to delete the static entry.
dynamic - Specifies to delete those dynamic entries.
all - Specifies that all entries include static and dynamic entries will be deleted.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete a neighbor cache entry on IP interface “System”:
DGS-1510-28XMP/ME:admin# delete ipv6 neighbor_cache ipif System 3ffc::1
Command: delete ipv6 neighbor_cache ipif System 3FFC::1
Success.
DGS-1510-28XMP/ME:admin#
33-3 show ipv6 neighbor_cache ipif
Description
This command is used to display the neighbor cache entry for the specified interface. You can display a specific
entry, all entries, or all static entries.
Format
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic | all]
Parameters
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters long.
all - Specifies that all the interface will be displayed.
ipv6address - Specifies the neighbor’s address.
<ipv6addr> - Enter the IPv6 address here.
static - Specifies the static neighbor cache entry.
dynamic - Specifies the dynamic entries.
all - Specifies that all entries include static and dynamic entries.