D-Link DGS-1510/ME Series - Page 331

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
327
DGS-1510-28XMP/ME:admin# show lldp local_ports 1 mode normal
Command: show lldp local_ports 1 mode normal
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype : Local
Port ID : 1
Port Description : D-Link DGS-1510-28XMP/ME R1.00.
018 Port 1
Port PVID : 1
Management Address Count : 1
PPVID Entries Count : 0
VLAN Name Entries Count : 1
Protocol Identity Entries Count : 0
MAC/PHY Configuration/Status : (See Detail)
Power Via MDI : (See Detail)
Link Aggregation : (See Detail)
Maximum Frame Size : 1536
DGS-1510-28XMP/ME:admin#
To display outbound LLDP advertisements for port 1 in brief mode:
DGS-1510-28XMP/ME:admin# show lldp local_ports 1 mode brief
Command: show lldp local_ports 1 mode brief
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype : Local
Port ID : 1
Port Description : D-Link DGS-1510-28XMP/ME R1.00.
018 Port 1
DGS-1510-28XMP/ME:admin#
38-11 show lldp remote_ports
Description
This command is used to display the information learned from the neighbor parameters.
Format
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
Parameters
<portlist> - (Optional) Specifies a range of ports to be configured. When port list is not specified, information for
all ports will be displayed.
mode – (Optional) Specifies to display the information in various modes.