DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
400
Restrictions
Only Administrators can issue this command.
Example
To clear all STP counters on the Switch:
DGS-1510-28XMP/ME:admin# debug stp clear counter ports all
Command: debug stp clear counter ports all
Success.
46-6 debug stp state
Description
This command is used to enable or disable the STP debug state.
Format
debug stp state [enable | disable]
Parameters
enable - Specifies to enable the STP debug state.
disable - Specifies to disable the STP debug state.
Restrictions
Only Administrators can issue this command.
Example
To configure the STP debug state to enable, and then disable the STP debug state:
DGS-1510-28XMP/ME:admin# debug stp state enable
Command: debug stp state enable
Success.
DGS-1510-28XMP/ME:admin# debug stp state disable
Command: debug stp state disable
Success.
To Next Page
Loading...
