D-Link DGS-1510/ME Series - Page 437

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
433
49-15 show stp instance
Description
This command is used to display each instance parameters settings. Value means the instance ID, if there is no
input of this value, all instance will be shown.
Format
show stp instance {<value 0-7>}
Parameters
<value 0-7> - (Optional) Enter the MSTP instance ID value here. This value must be between 0 and 7.
Restrictions
None.
Example
To show STP instance:
DGS-1510-28XMP/ME:admin# show stp instance
Command: show stp instance
STP Instance Settings
---------------------------
Instance Type : CIST
Instance Status : Enabled
Instance Priority : 32768(bridge priority : 32768, sys ID ext : 0 )
STP Instance Operational Status
--------------------------------
Designated Root Bridge : 32768/00-22-22-22-22-00
External Root Cost : 0
Regional Root Bridge : 32768/00-22-22-22-22-00
Internal Root Cost : 0
Designated Bridge : 32768/00-22-22-22-22-00
Root Port : None
Max Age : 20
Forward Delay : 15
Last Topology Change : 2430
Topology Changes Count : 0
DGS-1510-28XMP/ME:admin#