D-Link DGS-1510/ME Series - Page 454

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
450
status - Specifies to display the Ethernet OAM status.
configuration - Specifies to display the Ethernet OAM configuration.
statistics - Specifies to display Ethernet OAM statistics.
event_log - Specifies to display the Ethernet OAM event log information.
index - (Optional) Specifies an index range to display.
<value_list> - (Optional) Enter an index range to display.
Restrictions
Only Administrators and Operators can issue this command.
Example
To display Ethernet OAM statistics information for port 1:
DGS-1510-28XMP/ME:admin# show ethernet_oam ports 1 statistics
Command: show ethernet_oam ports 1 statistics
Port 1
------------------------------------------------------------
Information OAMPDU TX : 0
Information OAMPDU RX : 0
Unique Event Notification OAMPDU TX : 0
Unique Event Notification OAMPDU RX : 0
Duplicate Event Notification OAMPDU TX: 0
Duplicate Event Notification OAMPDU RX: 0
Loopback Control OAMPDU TX : 0
Loopback Control OAMPDU RX : 0
Variable Request OAMPDU TX : 0
Variable Request OAMPDU RX : 0
Variable Response OAMPDU TX : 0
Variable Response OAMPDU RX : 0
Organization Specific OAMPDUs TX : 0
Organization Specific OAMPDUs RX : 0
Unsupported OAMPDU TX : 0
Unsupported OAMPDU RX : 0
Frames Lost Due To OAM : 0
DGS-1510-28XMP/ME:admin#
52-3 clear ethernet_oam ports
Description
This command is used to clear Ethernet OAM information.
Format
clear ethernet_oam ports [<portlist> | all] [event_log | statistics]