D-Link DGS-1510/ME Series - Page 466

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
462
Example
To show all the port security entries:
DGS-1510-28XMP/ME:admin# show port_security_entry
Command: show port_security_entry
MAC Address VID Port Lock Mode
----------------- ---- ----- ---------------
00-00-00-00-00-01 1 25 DeleteOnTimeout
Total Entries: 1
DGS-1510-28XMP/ME:admin#
55-7 show port_security
Description
This command is used to display the port security related information, including state, maximum learned addresses
and lock address mode on a port and/or on a VLAN.
If both ports and vlanid (or vlan_name) are specified, configurations matching any of these parameters will be
displayed.
Format
show port_security {ports {<portlist>} {[vlan <vlan_name 32> | vlanid <vidlist>]}}
Parameters
ports - (Optional) Specifies the range of ports that will show their configuration.
<portlist> - (Optional) Enter the list of ports used for this configuration here.
vlan - (Optional) Specifies the name of the VLAN that will show its configuration.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Specifies the ID of the VLAN that will show its configuration.
<vidlist> - Enter the VLAN ID list here.
If no parameter is specified, the entries on all ports will be displayed.
Restrictions
None.
Example
To display the global configuration of port security: