D-Link DGS-1510/ME Series - Page 561

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
557
67-25 enable snmp authenticate_traps
Description
This command is used to enable SNMP authentication failure trap support.
Format
enable snmp authenticate_traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable SNMP authentication trap support:
DGS-1510-28XMP/ME:admin# enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
DGS-1510-28XMP/ME:admin#
67-26 disable snmp authenticate_traps
Description
This command is used to disable SNMP authentication failure trap support.
Format
disable snmp authenticate_traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To disable SNMP authentication trap support: