D-Link DGS-1510/ME Series - Single IP Management Command List; enable sim

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
564
Chapter 68 Single IP Management Command
List
enable sim
disable sim
show sim {[candidates {<candidate_id 1-100>} | members {<member_id 1-32>} | group {commander_mac
<macaddr>} | neighbor]}
reconfig {member_id <value 1-32> | exit}
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
config sim [{[commander {group_name <groupname 64>} | candidate] | dp_interval <sec 30-90> | hold_time
<sec 100-255>}]
download sim_ms [firmware_from_tftp | configuration_from_tftp] {<ipaddr> <path_filename> {[members <mslist
1-32> | all]}}
upload sim_ms [configuration_to_tftp | log_to_tftp] {<ipaddr> <path_filename> {[members <mslist> | all]}}
config sim trap [enable | disable]
68-1 enable sim
Description
This command is used to configure the single IP management on the Switch as enabled.
Format
enable sim
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable SIM:
DGS-1510-28XMP/ME:admin# enable sim
Command: enable sim
Success.
DGS-1510-28XMP/ME:admin#