D-Link DGS-1510/ME Series - Page 603

DGS-1510/ME Series Metro Ethernet Switch CLI Reference Guide
599
tech_support_file - (Optional) Specifies specifying the pathname supports “upload tech_support_toTFTP”
function.
<path_filename 64> - Enter specifying the pathname supports “upload tech_support_toTFTP” function.
debug_error_log_file - (Optional) Specifies the pathname supports “debug error_log” function.
<path_filename 64> - Enter the pathname supports “debug error_log” function.
sim_firmware_file - (Optional) Specifies the pathname supports “download/upload sim_ms firmware_fromTFTP”
function.
<path_filename 64> - Enter the pathname supports “download/upload sim_ms firmware_fromTFTP” function.
sim_cfg_file - (Optional) Specifies the pathname supports “download/upload sim_ms configuration_fromTFTP”
function.
<path_filename 64> - Enter the pathname supports “download/upload sim_ms configuration_fromTFTP”
function.
sim_log_file - (Optional) Specifies the pathname supports “upload sim_ms log_toTFTP” function.
<path_filename 64> - Enter the pathname supports “upload sim_ms log_toTFTP” function.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure TFTP server:
DGS-1510-28XMP/ME:admin# config tftp server 10.90.90.10
Command: config tftp server 10.90.90.10
Success.
DGS-1510-28XMP/ME:admin#
To configure TFTP server and specify the pre defined firmware file, log file:
DGS-1510-28XMP/ME:admin# config tftp server 10.90.90.1 firmware_file DES3200.had cfg_file
log_tmp
Command: config tftp server 10.90.90.1 firmware_file DES3200.had cfg_file log_tmp
Success.
DGS-1510-28XMP/ME:admin#
73-4 show tftp
Description
This command is used to show the TFTP server and the file path pre-configured by administer.
Format
show tftp