xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
237
Example
To enabled the DHCPv6 relay debug function:
DGS-3120-24TC:admin#debug dhcpv6_relay state enable
Command: debug dhcpv6_relay state enable
Success.
22-16 debug dhcpv6_relay state disable (EI Mode Only)
Description
This command is used to disable DHCPv6 relay debug functions.
Format
debug dhcpv6_relay state disable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To disable DHCPv6 relay debug functions:
DGS-3120-24TC:admin#debug dhcpv6_relay state disable
Command: debug dhcpv6_relay state disable
Success.
22-17 debug dhcpv6_relay output (EI Mode Only)
Description
This command is used to set the debug message to output to a buffer or a console.
Format
debug dhcpv6_relay output [buffer | console]
To Next Page
Loading...
