xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
238
Parameters
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrator-level users can issue this command.
Example
To set debug information to output to a console:
DGS-3120-24TC:admin#debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
22-18 debug dhcpv6_relay packet (EI Mode Only)
Description
This command is used to enable or disable the debug information flag of the DHCPv6 relay packet,
including packets receiving and sending.
Format
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specify the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enabled the DHCPv6 relay packet sending debug:
DGS-3120-24TC:admin#debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
To Next Page
Loading...
