Unified Services Router CLI Reference Guide
121
12.35 vpn sslvpn users users delete
<ltrow_id>
12.36 vpn ipsec policy configure <ltname>
vpn policy configuration mode
Save vpn policy configuration changes.
Roll back vpn policy configuration
changes.
Save vpn policy configuration changes
and exit current mode.
Setting policy manual or auto
Setting version ikev1 or ikev2
general_ip_protocol_version
Setting protocol version ipv4 or ipv6
Setting ipsec mode for the vpn policy
general_select_local_gateway
Setting local gateway for the vpn policy
general_remote_end_point_type
Set mode to IP address or Internet
Name/FQDN of the remote gatew ay or
client PC
vpn remote end point type
The IP address or Internet Name/FQDN
of the remote gatew ay or client PC.
general_remote_end_point ip_address
The IP address of the remote gatew ay or
client PC.
IPV4 or IPv6 address
depending upon protocol
selected IPV4 or IPV6
general_remote_end_point fqdn
The IP address or Internet Name/FQDN
of the remote gatew ay or client PC.
general_enable_mode_config
enable/disable mode config
enable/disable this to allow NetBIOS
broadcasts to travel over the VPN tunnel.
Setting protocol esp or ah
general_local_netw ork_type
Select the IP addresses on the local side
that w ill be part of the tunnel. This can be
either a single IP address, several IP
addresses in a range, an entire subnet,
or any IP address that w ants to connect
general_local_start_address
IP address from w here the range needs
to begin
IPV4 or IPv6 address
depending upon protocol
selected IPV4 or IPV6
general_local_end_address
IP address w here the range needs to
end