Unified Services Router CLI Reference Guide
20
Chapter 7. Configure commands used
in CLI
The configure commands for all the branches mentioned above are d iscussed in this s ection.
The command net ? at the CLI prompt would give the description of all the configuration
commands in the branch net, which is as follows:
ipv6 tunnel configuration setup.
net ipv6_tunnel six_to_four
six to f our tunnel configuration setup.
net ipv6_tunnel six_to_four configure
six To Four Tunnel configuration mode.
It gives options to add/edit/delete a bandwidth
profile.
net bandw idth profile enable <ltenable>
It allow s to enable/disable bandwidth profiles.
net bandwidth profile add
It allow s to add a bandwidth profile.
net bandwidth profile edit <ltrow_id>
It allow s to edit a bandwidth profile.
net bandwidth profile delete <ltrow_id>
It allow s to delete a bandwidth profile.
net bandwidth traffic_selector
It gives options to add/edit/delete a traffic selector
f or a bandwidth profile.
net bandwidth traffic_selector add
It allow s to add a traffic selector for a bandwidth
profile.
net bandwidth traffic_selector edit
<ltrow _id>
It allow s to edit a traffic selector for a bandwidth
profile.
net bandwidth traffic_selector delete
<ltrow _id>
It allow s to delete a traffic selector for a bandwidth
profile.
net lan dhcp reserved_ip configure
<ltmac_address>
DHCP Reserved IPs add/edit mode.
net lan dhcp reserved_ip delete
<ltmac_address>
Delete a specific reserved ip entry.
DHCP client configuration mode
DHCP client configuration mode
net dmz dhcp reserved_ip configure
<ltmac_address>
DHCP Reserved IPs add/edit mode.
net dmz dhcp reserved_ip delete
<ltmac_address>
Delete a specific reserved ip entry.
net ethernet configure <ltinterface_name>
Ethernet configuration mode.