Unified Services Router CLI Reference Guide
34
8.15 net ethernet configure <ltinterface_name>
Ethernet configuration mode.
Save ethernet configuration changes
Save ethernet configuration changes and exit
current mode.
Roll back configuration changes.
Enable/Disable VLAN for this interface.
Enable/Disable native VLAN status.
8.16 net lan ipv4 configure
Save LAN configuration changes.
Save LAN configuration changes and exit
current mode.
Roll back LAN configuration changes.
Set system LAN IP address.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
Set system LAN subnet mask.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
Set dhcp servers start address.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
Set dhcp servers end address.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
Set dhcp default gateway.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
Set secondary dns server.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255
number in range of 1 to 262800
Set dhcp relays gateway address.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-255