Unified Services Router CLI Reference Guide
62
Helps to determine the OSPFv2
designated router for a netw ork.The
router with the highest priority w ill be
more eligible to become Designated
Router. Setting the value to 0, makes the
router ineligible to be come Designated
Router. The default value is 1.
The number of seconds for HelloInterval
timer value.Setting this value, Hello
packet w ill be sent every timer value
seconds on the specified interface. This
value must be the same for all routers
attached to a common network. The
default value is 10 seconds.
The number of seconds that a
device’s hello packets must not have
been seen before its neighbors declare
the OSPF router dow n.This value must
be the same for all routers attached to a
common network.The default value is 40
seconds.
The cost of sending a packet on an
OSPFv2 interface
Give the authentication type used for
OSPFv2.If Authentication type is none
the interface does not authenticate ospf
packets.If Authentication Type is Simple
then ospf packets are authenticated
using simple text key.If Authentication
Type is MD5 then the interface
authenticates ospf packets with MD5
authentication.
Text Key for Simple Authentication type
8.39 net routing ospfv3 configure <ltinterface>
ospfv3 configuration mode.
Save OSPFv3 configuration changes.
Save OSPFv3 configuration changes and
exit current mode.
Roll back configuration changes.
Enable/Disable OSPFv3 for a particular
interface.
Helps to determine the OSPFv3
designated router for a network.The
router with the highest priority w ill be
more eligible to become Designated
Router. Setting the value to 0, makes the
router ineligible to beco me Designated
Router. The default value is 1.
The number of seconds for HelloInterval
timer value.Setting this value, Hello
packet w ill be sent every timer value
seconds on the specified interface. This
value must be the same for all routers
attached to a common network. The
default value is 10 seconds.