Unified Services Router CLI Reference Guide
48
assign an IP address to the router using
PPPOE netw ork protocol. Otherwise
Enter No and give valid static IP address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
dual_pppoe get_ip_from_phy
Enter Yes to get ip on physical interface
from dhcp server in the internal isp
network. Otherwise Enter No and give
valid static IP address, subnet mask and
gatew ay
Valid IP Address of physical interface
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
dual_pppoe subnet_mask_phy
Valid subnet mask of physical netw ork
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Valid gatew ay of physcial network
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
dual_pppoe
get_dns_from_isp_phy
Enter Yes to get dns dynamically from
interal ISP if you have not been assigned
any static Dns address. The internal ISP
w ill automatically assign an DNS address
to the router using Dhcp netw ork
protocol. Otherw ise Enter No and give
valid static dns addresses
dual_pppoe primary_dns_phy
Valid primary DNS Server IP Address of
physical netw ork
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
dual_pppoe secondary_dns_phy
Valid secondary DNS Server IP Address
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
8.31 net wan wan2 ipv4 configure
Save ipv4 w an configuration changes.
Roll back ipv4 w an configuration
changes.
Save ipv4 w an configuration changes
and current mode.
Select among the options: STATIC,
DHCP Client, PPPoE, PPTP, L2TP,
Russian PPTP, Russian L2TP, Japanese
Multiple PPPoE, Dual Access Pppoe
If ISP Type selected is DHCPC, this field
gives you options to configure DHCPC
credentials
Enter Yes to get dns dynamically from
ISP if you have not been assigned any
static IP address. The ISP w ill