Unified Services Router CLI Reference Guide
13
Chapter 5. Show commands used in
CLI
The show commands for all the above mentioned branches are outlined in this section.
The command show net ? at the CLI prompt would give the description of all the show
commands in the branch net, which is as follows:
show net ipv6_tunnel status
Display ipv6 tunnels status
show net bandwidth profile
show net bandwidth profile setup
Show list of Available Bandwidth Profile(s).
show net bandwidth traffic_selector
show net bandwidth traffic_selector setup
Show list of Available Traffic Selector(s).
Show Dynamic DNS Configuration.
show net lan dhcp reserved_ip
show net lan dhcp reserved_ip setup
Show list of DHCP Reserved Addresses.
show net lan dhcp leased_clients
show net lan dhcp leased_clients list
Show list of Available DHCP Leased Clients.
Display dhcp client Configuration.
show net dmz dhcp reserved_ip
show net dmz dhcp reserved_ip setup
Show list of DMZ DHCP Reserved Addresses.
show net dmz dhcp leased_clients
show net dmz dhcp leased_clients list
Show list of Available DMZ DHCP Leased Clients.
show net statistics <ltinterface>
Show Interface Statistics
show IntelAmt server details
show net intel_Amt server
show IntelAmt Server Configurations
show net intel_Amt Reflector
show IntelAmt Reflector Configuration
show net intel_Amt server setup
Display net Intel_Amt server setup.
show net intel_Amt Reflector setup
Display net Intel_Amt Reflector setup.
show Ip Alias server details
show Ip Alias configuration details
show net Ip_Alias server setup
Display net Intel_Amt server setup.
Display IP MODE configuration
show net ipv6_tunnel setup
Display ipv6 tunnels configuration
show net routing mode setup
Routing Mode betw een WAN and LAN