Unified Services Router CLI Reference Guide
79
The port number to use for DNAT, required if port
forwarding is enabled
enable/disable port forwarding based on this firewall
rule configuration settings
Send to Local Server (DNAT IP),Specifies an IP
address and port number of a machine on the Local
Netw ork which is hosting the server.
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Set it as Dedicated/configured WAN
9.14 security firewall ipv4
default_outbound_policy
<ltdefault_outbound_policy>
<ltdefault_outbound_policy>
Firew all Settings, Default Outbound Policy configuration mode.
9.15 security firewall ipv4 edit <ltrow_id>
Firew all IPV4 rules configuration mode.
Save Firew all IPV4 rules configuration changes.
Save Firew all IPV4 rules configuration changes and
exit current mode.
Roll back IPV4 rules configuration changes.
Set from Zone security type
Set From Zone VLAN using corresponding VLAN
name
Set to Zone security type
Set To Zone VLAN using corresponding VLAN name
Name of the custom service for which a rule is to be
added custom name should already be added into
custom service
Name of the service for which a rule is to be added
Action to be taken by the rule
firew all rule action type
Name of schedule for which the rule is applicable
firew all rule address type
Type of the destination user
firew all rule address type
firew all rule snat address type
firew all rule log enable/disable
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-