EasyManua.ls Logo

D-Link DSR-1000 - Page 231

D-Link DSR-1000
251 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
231
付録D ćƒ­ć‚°ćƒ”ćƒƒć‚»ćƒ¼ć‚ø
ćƒ­ć‚°ćƒ”ćƒƒć‚»ćƒ¼ć‚ø ē·Šę€„åŗ¦ ćƒ­ć‚°ćƒ”ćƒƒć‚»ćƒ¼ć‚ø ē·Šę€„åŗ¦
Enabling Management Access from Internet on port DEBUG Enabling Port Trigger Rule for %d:%d:%d:%d:%d DEBUG
Enabling remote access management for IP address range"
DEBUG Disabling Port Trigger Rule for %d:%d:%d:%d:%d DEBUG
Enabling remote access management to only this PC. DEBUG Adding Port Trigger Rule for %d:%d:%d:%d:%d DEBUG
Disabling Management Access from Internet on port %d
DEBUG Enabling Content Filter DEBUG
Disabling remote access management for IP address range"
DEBUG Disabling Content Filter DEBUG
Disabling remote access management only to this PC. DEBUG Enabling Content Filter DEBUG
MAC Filtering %sabled for BLOCK and PERMIT REST. DEBUG Setting NAT mode for pLogicalIfName = %s DEBUG
MAC Filtering %sabled for PERMIT and BLOCK REST. DEBUG Enabling DROP for INPUT DEBUG
Enabling Content Filtering. DEBUG Enabling DROP for FORWARD DEBUG
Disabling Content Filtering. DEBUG Enabling NAT based Firewall Rules DEBUG
Deleting rule, port triggering for protocol TCP. DEBUG Setting transparent mode for pLogicalIfName \ DEBUG
Deleting rule, port triggering for protocol UDP. DEBUG Enabling Accept for INPUT DEBUG
Deleting rule, port triggering for protocol TCP. DEBUG Enabling Accept for FORWARD DEBUG
Deleting rule, port triggering for protocol UDP. DEBUG Setting Routing mode for pLogicalIfName \ DEBUG
Enabling rule, port triggering for protocol TCP. DEBUG Enabling DROP for INPUT DEBUG
Enabling rule, port triggering for protocol UDP. DEBUG Enabling DROP for FORWARD DEBUG
Enabling rule, port triggering for protocol TCP. DEBUG Disabling NAT based Firewall Rules DEBUG
Enabling rule, port triggering for protocol UDP. DEBUG Enabling Firewall Rules for URL Filtering & " DEBUG
Enabling DNS proxy. DEBUG Adding Firewall Rule for RIP Protocol DEBUG
Restarting DNS proxy. DEBUG Restarting Schedule Based Firewall Rules DEBUG
checking DNS proxy for Secure zone. DEBUG enabling IPS checks between %s and %s zones. DEBUG
checking DNS proxy for Public zone. DEBUG disabling IPS checks between %s and %s zones. DEBUG
Enabling Block tra󱐰c from %s zone. DEBUG Stopping IPS...%s DEBUG
Conī™°guring ī™°rewall session settings for " DEBUG IPS started. DEBUG
Disabling DMZ DEBUG Route already exists DEBUG
Disabling WAN-DMZ rules . DEBUG Route addition failed: Network Unreachable DEBUG
Enabling WAN DMZ rules . DEBUG Route addition failed: Network is down DEBUG
Restarting DMZ rule having %s address with %s address.
DEBUG Route addition failed DEBUG
Enabling LAN DHCP relay. DEBUG Failed to add rule in iptables DEBUG
OneToOneNat conī™°gured successfully DEBUG Failed to delete rule from iptables DEBUG
OneToOneNat conī™°guration failed DEBUG fwLBSpillOverConī™°gure: Something going wrong here ERROR
Deleting scheduled IPv6 rules. DEBUG fwLBSpillOverConī™°gure: unable to get interfaceName ERROR
delete from FirewallRules6 where ScheduleName = '%s'.
DEBUG
fwLBSpillOverConī™°gure: Could not set PREROUTING rules
ERROR
Update FirewallRules6 where ScheduleName = '%s' to New "
DEBUG
fwLBSpillOverConī™°gure: Could not set POSTROUTING rules
ERROR
Dns proxy Restart failed DEBUG fwLBSpillOverConī™°gure: Something going wrong Here ERROR
deleting interface to ifgroup failed DEBUG
fwL2TPGenericRules.c: unable to open the database ī™°le "
ERROR
adding interface to ifgroup failed DEBUG fwL2TPGenericRules.c: inet_aton failed ERROR
deleting interface pVirtIface %s from ifgroup %d" DEBUG
fwPPTPGenericRules.c: unable to open the database ī™°le "
ERROR
adding interface pVirtIface %s to ifgroup %d failed DEBUG fwPPTPGenericRules.c: inet_aton failed ERROR
Deleting IP address %s. DEBUG DNS proxy ī™°rewall rule add failed for %s ERROR
Adding new IP address %s. DEBUG deleting interface %s from ifgroup %d failed ERROR
Updating old IP address %s to new IP address %s. DEBUG adding interface %s to ifgroup %d failed ERROR
Restarting Firewall For %s Address Update from %s:%s DEBUG nimfBridgeTblHandler: unable to get interfaceName ERROR
Disabling Firewall Rule for MSS packet marking DEBUG nimfBridgeTblHandler: \ ERROR
Enabling Firewall Rule for MSS packet marking DEBUG nimfBridgeTblHandler: unable to get \ ERROR
Enabling packet marking rule for %s IDLE timer DEBUG Failed to %s tra󱐰c from %s to %s to IPS. ERROR
Deleted ī™°rewall rule %s for service %s with action %s DEBUG Failed to %s tra󱐰c from %s to %s to IPS. ERROR
%s ī™°rewall rule %s for service %s with action %s DEBUG failed to start IPS service. ERROR
Added ī™°rewall rule %s for service %s with action %s DEBUG Timeout in waiting for IPS service to start. ERROR
Deleting inbound(WAN-LAN) ī™°rewall rule. DEBUG Usage:%s <DBFile> <opType> <tblName> <rowId> " ERROR
Deleting inbound(WAN-DMZ) ī™°rewall rule. DEBUG xlr8NatConī™°g: illegal invocation of (%s) ERROR
RIPng disabled. DEBUG Illegal invocation of [%s] ERROR
RIPng enabled. DEBUG xlr8NatMgmtTblHandler: failed query: %s ERROR
Disable IPv6 ī™°rewall rule. DEBUG Could not open ī™°le: %s ERROR

Table of Contents

Other manuals for D-Link DSR-1000

Related product manuals