D-Link DSR-250N - Page 246

Unified Services Router User Manual
244
Invalid config data
ERROR
Facility: Kernel
Log Message
Severity
Log Message
Severity
DNAT: multiple ranges no longer
supported
DEBUG
%s: %s%s:%d -> %s:%d %s,
DEBUG
DNAT: Target size %u wrong for %u
ranges,
DEBUG
%s: %s%s:%d %s,
DEBUG
DNAT: wrong table %s, tablename
DEBUG
%s: Failed to add WDS MAC: %s, dev-
>name,
DEBUG
DNAT: hook mask 0x%x bad,
hook_mask
DEBUG
%s: Device already has WDS mac
address attached,
DEBUG
%s%d: resetting MPPC/MPPE
compressor,
DEBUG
%s: Added WDS MAC: %s, dev-
>name,
DEBUG
%s%d: wrong offset value: %d,
DEBUG
%s: WDS MAC address %s is not
known by this interface,
DEBUG
%s%d: wrong length of match value:
%d,
DEBUG
[madwifi] %s() : Not enough space.,
__FUNCTION__
DEBUG
%s%d: too big offset value: %d,
DEBUG
Returning to chan %d, ieeeChan
DEBUG
%s%d: cannot decode offset value,
DEBUG
WEP
DEBUG
%s%d: wrong length code: 0x%X,
DEBUG
AES
DEBUG
%s%d: short packet (len=%d),
__FUNCTION__,
DEBUG
AES_CCM
DEBUG
%s%d: bad sequence number: %d,
expected: %d,
DEBUG
CKIP
DEBUG
%s%d: bad sequence number: %d,
expected: %d,
DEBUG
TKIP
DEBUG
PPPIOCDETACH file->f_count=%d,
DEBUG
%s: cannot map channel to mode; freq
%u flags 0x%x,
DEBUG
PPP: outbound frame not passed
DEBUG
%s: %s, vap->iv_dev->name, buf
DEBUG
PPP: VJ decompression error
DEBUG
%s: [%s] %s, vap->iv_dev->name,
DEBUG
PPP: inbound frame not passed
DEBUG
%s: [%s] %s, vap->iv_dev->name,
ether_sprintf(mac), buf
DEBUG
PPP: reconstructed packet
DEBUG
[%s:%s] discard %s frame, %s, vap-
>iv_dev->name,
DEBUG
PPP: no memory for
DEBUG
[%s:%s] discard frame, %s, vap-
>iv_dev->name,
DEBUG
missed pkts %u..%u,
DEBUG
[%s:%s] discard %s information
element, %s,
DEBUG
%s%d: resetting MPPC/MPPE
compressor,
DEBUG
[%s:%s] discard information element,
%s,
DEBUG
%s%d: wrong offset value: %d,
DEBUG
[%s:%s] discard %s frame, %s, vap-
>iv_dev->name,
DEBUG
%s%d: wrong length of match value:
%d,
DEBUG
[%s:%s] discard frame, %s, vap-
>iv_dev->name,
DEBUG
%s%d: too big offset value: %d,
DEBUG
ifmedia_add: null ifm
DEBUG
%s%d: cannot decode offset value,
DEBUG
Adding entry for
DEBUG
%s%d: wrong length code: 0x%X,
DEBUG
ifmedia_set: no match for 0x%x/0x%x,
DEBUG
%s%d: short packet (len=%d),
__FUNCTION__,
DEBUG
ifmedia_set: target
DEBUG
%s%d: bad sequence number: %d,
expected: %d,
DEBUG
ifmedia_set: setting to
DEBUG