D-Link DSR-250N - Page 255

Unified Services Router User Manual
253
test key, key
DEBUG
%s: %s (, dev_info, ath_hal_version
INFO
pre-hashed key, key DEBUG %s: driver unloaded, dev_info INFO
const char *descr, krb5_keyblock *k) {
DEBUG
%s: driver unloaded, dev_info
INFO
AES 128-bit key, &key
DEBUG
%s: Version 2.0.0
INFO
const char *descr, krb5_keyblock *k) {
DEBUG
%s: driver unloaded, dev_info
INFO
test key, key
DEBUG
%s: driver unloaded, dev_info
INFO
pre-hashed key, key
DEBUG
wlan: %s backend registered, be-
>iab_name
INFO
const char *descr, krb5_keyblock *k) {
DEBUG
wlan: %s backend unregistered,
INFO
128-bit AES key,&dk
DEBUG
wlan: %s acl policy registered, iac-
>iac_name
INFO
256-bit AES key, &dk
DEBUG
wlan: %s acl policy unregistered, iac-
>iac_name
INFO
WARNING:
DEBUG
%s: %s, dev_info, version
INFO
bwMonMultipathNxtHopSelect::
checking rates
DEBUG
%s: driver unloaded, dev_info
INFO
hop :%d dev:%s usableBwLimit = %d
currBwShare = %d lastHopSelected =
%d weightedHopPrefer = %d ,
DEBUG
%s: %s (, dev_info, ath_hal_version
INFO
1. selecting hop: %d lastHopSelected =
%d , selHop, lastHopSelected
DEBUG
%s: driver unloaded, dev_info
INFO
4. hop :%d dev:%s usableBwLimit = %d
currBwShare = %d lastHopSelected =
%d weightedHopPrefer = %d ,
DEBUG
%s: %s: mem=0x%lx, irq=%d,
INFO
2. selecting hop: %d lastHopSelected =
%d , selHop, lastHopSelected
DEBUG
%s: %s, dev_info, version
INFO
3. selecting hop: %d lastHopSelected =
%d , selHop, lastHopSelected
DEBUG
%s: driver unloaded, dev_info
INFO
bwMonitor multipath selection enabled
DEBUG
ath_pci: switching rfkill capability %s,
INFO
bwMonitor multipath selection disabled
DEBUG
Unknown autocreate mode: %s,
INFO
weightedHopPrefer set to
%d ,weightedHopPrefer
DEBUG
%s: %s: mem=0x%lx, irq=%d,
INFO
bwMonitor sysctl registration failed
DEBUG
%s: %s, dev_info, version
INFO
bwMonitor sysctl registered
DEBUG
%s: driver unloaded, dev_info
INFO
bwMonitor sysctl not registered
DEBUG
%s: %s, dev_info, version
INFO
Unregistered bwMonitor sysctl
DEBUG
%s: unloaded, dev_info
INFO
CONFIG_SYSCTL enabled ...
DEBUG
%s: %s, dev_info, version
INFO
Initialized bandwidth monitor ...
DEBUG
%s: unloaded, dev_info
INFO
Removed bandwidth monitor ...
DEBUG
%s: %s, dev_info, version
INFO
Oops.. AES_GCM_encrypt failed
(keylen:%u),key->cvm_keylen
DEBUG
%s: unloaded, dev_info
INFO
Oops.. AES_GCM_decrypt failed
(keylen:%u),key->cvm_keylen
DEBUG
failed to create procfs entry .
INFO
%s, msg
DEBUG
ICMP: %u.%u.%u.%u:
INFO
%02x%s, data[i],
DEBUG
ICMP: %u.%u.%u.%u: Source
INFO
Failed to set AES encrypt key
DEBUG
Wrong address mask %u.%u.%u.%u
from
INFO
Failed to set AES encrypt key
DEBUG
Redirect from %u.%u.%u.%u on %s
about
INFO
AES %s Encrypt Test Duration: %d:%d,
hard ? Hard : Soft,
DEBUG
IP: routing cache hash table of %u
buckets, %ldKbytes,
INFO
Failed to set AES encrypt key
DEBUG
source route option %u.%u.%u.%u ->
%u.%u.%u.%u,
INFO