D-Link DWC-2000 - Page 21

19
The command “show POP3-Settings ?” at the CLI prompt, gives a
description of all the show commands in the branch POP3-Settings , these are
as follows:
1
show POP3-Settings
Display POP3 configuration.
The command “show POP3-Trusted-CA ?” at the CLI prompt, gives a
description of all the show commands in the branch POP3-Trusted-CA , these
are as follows:
1
show POP3-Trusted-CA
Display POP3 Trusted Certificates.
The command “show system ?” at the CLI prompt, gives a description of all
the show commands in the branch system , these are as follows:
1
show system logging
Display Logging
Configuration.
2
show system logging remote
.
3
show system logging remote setup
Display remote logging
configuration.
4
show system logging facility
.
5
show system logging facility
setup <facility>
Display logging facility
configuration.
6
show system logging ipv4
.
7
show system logging ipv4 setup
Display logging
configuration.
8
show system logging ipv6
.
9
show system logging ipv6 setup
Display ipv6 logs
configuration.
10
show system
remote_management
Display Remote
management
configuration.
11
show system
remote_management setup
Display remote
management over
https configuration.
12
show system snmp <agentIP>
Display SNMP
configuration.
13
show system status
Display system status.
14
show system dashboard
Displays the resources
being used in the
system currently.
15
show system time
Display TimeZone
Configuration.