Software User Manual D-Link Unified Access System
02/15/2011
Document 34CS3000-SWUM104-D10 Page 111
Click the Start button to manually run the power adjustment feature.
The Current Status of the plan shows one of the following states:
• None—The power adjustment algorithm has not been manually run since the last switch reboot.
• Algorithm In Progress—The power adjustment algorithm is running.
• Algorithm Complete—The power adjustment algorithm has finished running.
A table displays to indicate proposed power adjustments. Each entry shows the AP along with the current and new power
levels. To accept the proposed change, click Apply. You must manually apply the power adjustment for the proposed
assignments to be applied.
• Apply In Progress—The switch is adjusting the power levels that the APs use.
• Apply Complete—The algorithm and power adjustment are complete.
Use the buttons at the bottom of the page to perform the following tasks:
• Click Clear to reset the page to the default values.
• Click Refresh to update the screen with the most current information.
Upgrading the Access Point Software
The D-Link Unified Switch can upgrade software on the APs that it manages. To upgrade one or more D-Link Access Point
from the switch that manages it, click the WLAN > Administration > AP Management > Software Download.
To Next Page
Loading...
